What a kit costs
Priced per plate, so the kit price follows the job rather than a package tier. No setup fee, no minimum order, no account — one disconnect tag is a real order and it still gets cut. Build your kit on this site and the price updates as you answer.
Sizes
| Size | Metric | Used for | What it carries |
|---|---|---|---|
| 6″ × 4″ | 152.4 × 101.6 mm | Diagram plates | Single-line diagram plates and the first-responder placard — the tags that carry real content. |
| 6″ × 2″ | 152.4 × 50.8 mm | Main placards | Main service warnings and the two-power-source plates at the meter base. |
| 4″ × 2″ | 101.6 × 50.8 mm | Multi-line warnings | Multi-line warnings and equipment data plates. Thirty labels in the catalogue use it. |
| 4″ × 1″ | 101.6 × 25.4 mm | Equipment ID | Equipment identification — the most common size on a solar job. Forty labels use it. |
Worked kits
| Job | Plates | Kit price |
|---|---|---|
| House — string inverter | 21 | $198.06 |
| House — microinverters | 16 | $166.15 |
| House — with battery | 24 | $241.38 |
| Commercial rooftop | 29 | $368.49 |
| Ground mount / solar farm | 31 | $486.48 |
| Off-grid / cabin | 13 | $136.79 |
| Re-label an existing install | 7 | $64.12 |
Two tiers on every kit
Standard — the full set
Every placement the code and the utility standard call for. This is what you send when someone else’s inspector is going to look at it.
Minimum — only what the code permits
The same kit with the reductions the rule text itself allows, each with a citation behind it. Nothing an inspector can fail you for comes out. Two mechanisms:
Consolidation the rule allows. On a microinverter job, ESA Bulletin 64-5-4 A11/A12 lets the system ratings go on the 84-030(2) single-line plate instead of a separate plate — that alone removes a 6″ × 8″ at $54.72.
Collapsing meter-and-service-equipment pairs where the meter and the service equipment are genuinely one location.
Where the two tiers differ on an Ontario job it is a handful of plates, not half the kit. Same compliance, no corners.
A grid-tied kit does not get much below the seven-plate service set, and most of what is left is the diagram plates — the single-line and the first-responder placard — which carry the content that makes them big.
If the price has to be lower, the lever is a stock pre-nested SKU with no per-job layout or proofing — several kits nest on one sheet, so the setup amortises. That is a pricing decision, not a code decision.
Every label with its rule citation, jurisdiction and install location; a nested cut sheet; and a flag list of every blank that must be filled from the job before cutting — ratings, locations, equipment IDs — plus anything only the LDC or the inspector can confirm.